|
|
|||||
|
|
|
||||
|
The
CG-335 is a versatile charger that allows the user to charge multiple
battery packs at one time. The CG-335 incorporates a unique glow
igniter battery charging feature and a “Boosted Charging Method”
that charges up to 24 cells (28.8 Volts) from a 12 Volt source. Applications 4
– 24 cell, 270 – 3000mah packs
Features DC
to DC charging with Booster Circuit Delta
peak cut off with automatic trickle MOS-FET
drive control with pulse charging Initial
Cutoff Error Override Low
Battery Input Voltage Input
Battery Polarity Protection Output Battery Polarity Protection Charging
Port Short Protection Cutoff
method: Delta peak cutoff (Primary & Glow plug port only) Maximum
charge time: 65-minute
safety cutoff Specifications Wide
Input Voltage range:
9 – 15 Volt Input
Battery minimum capacity: 10A Charging Amperage Glow
(1 cell):
1.1A Upper
Port:
4-24cell: 0.5A – 5.5A Secondary Port: 250mah (.25A) constant rate
|
||||
CG-425 DC/DC 7.2V / 8.4V Charger TOP
|
|
|||
|
HAN-114 Double Vision Fast Field Charger TOP
|
|
||||||
|
HAN-7100 Glow Starter Quick Charger TOP
|
|
||||
| There
are not the time to get caught at the flying field with a dead
glow driver. Be prepared with this Glow starter Quick Charger. This quick
charger features a quick charge time of 20 min. for NiCad glow drivers,
providing enough energy to get you flying when you’re stuck with a dead
glow driver. After charging for 20 minutes at a 1 amp rate, the Ni-Charge
will auto-matically switch to a trickle charge rate of 50mA and safely
charge the NiCad battery to full capacity. Small and compact, the Charger will fit easily into most field boxes or can be attached to the side of your field box for easy access. For power, the Charger comes with banana plugs, so you can quickly attach it to your power panel. Operating the Ni-Charge couldn’t get any easier. A green LED lights when you connect the power input leads. Next, attach a NiCad glow driver onto the dummy glow plug recessed inside the Ni-Charge. Then, push the START button. A red LED illuminates during the quick charge cycle. Once completed, the red LED goes out, and your glow driver is ready for action.
|